EVALUATION OF THE DISTRIBUTION OF SIZE OF LIPID MICROPARTICLES BY LASER DIFFRACTION
Laser diffraction particle size analysis requires a stable state of dispersion of samples and appropriate measurement conditions. Wet dispersion of lipid microparticles is challenging due to agglomeration and floating, therefore, the methods usually includes using surfactants and adding energy to improve dispersion, by applying ultrasound and/or mechanical stirring. These parameters must be carefully evaluated in order to ensure the particles stability under the measurement conditions, especially for particles sensitive to mechanical shocks and heating. This study aimed the development of a method for evaluating the size distribution of lipid microparticles using a Mastersizer 2000 equipment. Several methods of sample preparation (dispersant, water or ethanol; addition of Tween™ 80 in the dispersant or directly on the particles) and operation parameters (time for the sample to stabilize before measuring, stirring speed and duration, use or not use of ultrasound) were evaluated. The selection of the method was based on parameters of reproducibility, obtaining monomodal distribution and stability of the particles along the measurement time. As a result, ethanol did not provide suitable particle dispersion. Regarding the operating conditions, most of the results presented multimodal distributions, with peaks at large particle sizes, due to the incomplete deagglomeration process; and at small sizes, probably due to the heating and instability of particles resulting from ultrasound and stirring during more than 10 minutes. The final method of sample dispersion consisted of preparing a slurry by adding Tween™ 80 directly on the sample (1:1,w/w), followed by manual stirring and later dispersion in 20mL of water; ultrasound (50% of intensity) and stirrer speed at 1750 rpm for 1 minute before measurements. This condition was used to evaluate microparticles stability over 12 weeks and presented consistent results, which shows the applicability and robustness of the developed method.