Para citar este trabalho use um dos padrões abaixo:
Development of low-fat lactose-free yogurts enriched with whey protein
Mylla Farias Cardoso de Moura
Universidade Federal do Rio de Janeiro
Agora você poderia compartilhar comigo suas dúvidas, observações e parabenizações
Crie um tópicoSeveral consumers have been looking for products rich in protein, reduced in sugar and fat, and lactose-free, stimulating the development of dairy products. However, the development of yogurts with defined amounts of whey(W), co-product of the cheese industry, and different types of whey protein concentrate (WPC), a high biological value protein, such as isolate (WPI) or hydrolyze (WPH), needs to be investigated. Therefore this research aims to produce four formulations of yogurts with mixture in a fixed proportion 35%W-65%skim milk (M) enriched or not with 3%protein (m/v) of WPC, WPI or WPH (M, M+WPC, M+WPI, M+WPH), and analyze physicochemical characteristics during storage (1, 7, 14, 21 and 28 days). Samples were heated(80°C/20min) and, after cooling, (43°C) were added with lactic culture(0.2U/L) and lactase(30U/g lactose). M+WPH flocculated after heating, possibly facilitated by denaturation of the smaller proteins chains. Fermentation kinetics was evaluated until pH 4.7, and in protein enriched samples fermentation time increasing from 3.5 to 4.0h and higher dry extract was reached (p<0.05). During storage, the pH varied from 4.5 to 4.7 for all samples, and acidity was lower than allowed by legislation for M. The water holding capacity (WHC) showed an increase of 184% in M+WPC and 255% in M+WPI (p<0,05) because of the power WHC of whey proteins. M+WPC viscosity after 7 days (50-60mPa.s) was 3x higher than M (p<0.05), both ideal for whipped yogurt, while M+WPI showed up to 3500mPa.s, ideal for traditional yogurt. Differences between M+WPC and M+WPI may be due to conformation modifications of proteins generated in the microfiltration process to obtain WPI from WPC. Therefore, the addition of WPC or WPI contributed to the characteristics and became attractive for the dairy industry, fitting to the next steps the study of other proportions of M, WPC, and WPI that will be used in sensory studies.
Lillyan Nathalia Brito Silva
Parabéns Mylla, pela apresentação tão clara e objetiva e pelo relevante trabalho sendo desenvolvido. Fiquei ainda mais expectante pelos futuros dados sensoriais.
Tendo em vista que o soro de leite é um co-produto da fabricação de queijos, o soro utilizado no seu estudo foi obtido de qual fonte? Alguma fábrica ou por elaboração prévia em laboratório?
E, também, fiquei curiosa em saber qual espécie de fermento lácteo foi utilizado.
Sucesso nos próximos passos da pesquisa!
Com ~200 mil publicações revisadas por pesquisadores do mundo todo, o Galoá impulsiona cientistas na descoberta de pesquisas de ponta por meio de nossa plataforma indexada.
Confira nossos produtos e como podemos ajudá-lo a dar mais alcance para sua pesquisa:
Esse proceedings é identificado por um DOI , para usar em citações ou referências bibliográficas. Atenção: este não é um DOI para o jornal e, como tal, não pode ser usado em Lattes para identificar um trabalho específico.
Verifique o link "Como citar" na página do trabalho, para ver como citar corretamente o artigo
Mylla Farias Cardoso de Moura
Olá Lillyan, nos utilizamos o soro de leite em pó desmineralizado, que é vendido comercialmente mesmo. Portanto, fazemos sua solubilização em água mineral para que se obtenha as mesmas concentrações de quando encontrado em sua forma originalmente liquida (in natura), que contém aproximadamente 93% de água, 5% de lactose, 0,9% de proteínas e de 0,5 a 0,3% de gordura. Quanto ao fermento lácteo, utilizamos o YF-L903 (0,1g/L) composto por Streptococcus salivarius subsp. thermophilus e Lactococcus delbrueckii subsp. bulgaricus (Chr. Hansen®, Hoershlom, Dinamarca).
Obrigada pela pergunta!!