Optimization of the parameters involved in bikaverin production by Fusarium oxysporum in rice media
Bikaverin is a red fungal pigment presenting interesting biological properties, such as antimicrobial and antitumoral activities. Therefore, this work intended to optimize the parameters of bikaverin production by Fusarium oxysporum CCT7620 cultured in conical flasks with rice-based medium. The optimization was performed by means of a central composite design (CCD) with three center points involving the following variables: temperature (21.3-34.7°C), agitation speed (71-289rpm) and rice concentration in the culture media (16.4-83.6g/L). The pre-inoculum was done by homogeneizing 1.5cm2 of a Potato Dextrose Agar 72h-old culture in 200mL of rice medium (50 g/L of rice in water) and subsequent cultivation at 30°C and 200rpm. After centrifugation (9000rpm/ 5 min) 0.4g of wet biomass was used to inoculate each flask to be further cultured under different conditions. The production of bikaverin was monitored each 24h (up to 96h) by analyzing the absorbance (500nm) of an ethyl acetate extrac (one part of exthyl acetate for each part of fermented culture medium). Considering the bikaverin production after 96h and a significance level of 10%, a valid model with R2 = 0.8901 and p < 0.00006 was proposed. Agitation presented a positive effect on bikaverin production while temperature and rice concentration negatively affected the response. The contour plots indicated that the maximal production could be achieved using higher agitations (250-289rpm), intermediate temperatures (25-28°C) and lower rice concentrations (16.4-20g/L). These results will guide the next steps in our research, i.e. production and purification of bikaverin to be used in food formulations and to be analyzed in terms of its biological properties.