This paper was published through Galoá and has a deposited DOI. To cite this paper, use one of the standards below:
In case you are one of the co-authors and want to register this paper in your Lattes, use the following code: doi > 10.59254/sbpo-2024-193808
If you've NEVER registered a DOI in your Lattes, check our tutorial!This work aims to optimize the end milling process of duplex stainless steel UNSS32205 to find optimal parameters of cutting speed, feed per tooth, milled width and depth of cut, aiming at the lowest roughness. The methodology adopted involves the use of a predictive model, based on an Artificial Neural Network as an objective function. An optimization meta-heuristic was adopted to find the optimum point of the milling process in question. The combination of the optimal parameters obtained resulted in a roughness of Ra = 0.5913637μm. Finally, the influence of noise on the optimum point was also evaluated through a graphical analysis to verify how uncontrollable factors impact the result obtained. It was found that noise has a significant impact on the process and that it should be taken into account during the analysis.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper