To cite this paper use one of the standards below:
The babassu mesocarp is a by-product of oil babassu production in the northern and north-eastern regions of Brazil. It represents a source of starch (~89%), that can be valorized to produce 3D printing food. The utilization of grape extracts and milk whey as ingredients in product development offers an additional approach to the valorisation of agro-food by-products, while providing nutrients and bioactive compounds that enhance functional and technological properties of food. Additionally, milk is widely consumed worldwide owing to its desirable sensory properties and high nutritional value. Thus, the objective of this study was to create edible 3D printing inks by blending babassu starch, grape extract, and milk-derived products. Formulations were prepared using 15g of babassu mesocarp starch for each 100mL of liquid phase: (1) Control (starch in water), (2) starch in 50mL of grape extract and plus 50mL of skim milk (3.4% protein); (3) starch with 2g of whey completed to 100 mL with grape extract. The babassu starch contains 3.26%±0.03 moisture, 1.30±0.01% ash, 0.64±0.01% lipids, 2.45±0.07% protein, and 95.68±0.22% carbohydrates. The grape extract contained TAC of 12.94±1,06 mg C3GE/L and TPC of 820.74±155.83 mg GAE/L. The suspensions were heated at 85°C during 20 minutes. Mechanical properties of the gels (maximum penetration force [mN], cohesion [mJ], maximum adhesion force [mN], adhesiveness [mJ]) and their rheological behavior (G' and G'') were evaluated. The MPF and cohesion of the gels varied (p<0.05) from 492.40±45.20a to 89.36±11.00c mN and from 3034.69±336.01a to 577.77±18.43c mJ, respectively. MAF and adhesiveness decreased in the skim milk–grape extract mixture (50:50 mL) but increased when whey and 100 mL of grape extract was used. This indicating that whey acted synergistically with the grape extract as a binding agent, which was absent in the skim milk matrix. All gels exhibited solid-like behavior (G′ > G″), indicating suitable rheological properties for preliminary syringe extrusion and potential 3D food printing scalability. These matrices show great promise as edible inks for food customization and the development of novel babassu-based products in Brazil.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper