This paper was published through Galoá and has a deposited DOI. To cite this paper, use one of the standards below:
In case you are one of the co-authors and want to register this paper in your Lattes, use the following code: doi > 10.17648/sobena-2024-195552
If you've NEVER registered a DOI in your Lattes, check our tutorial!In various offshore applications, carbon steel pipes (e.g., X65) are internally coated with a thin layer of corrosion-resistant material (e.g., stainless steel 304, 316) to protect them from the corrosive agents present in the hydrocarbons they carry, such as CO2 and H2S. Consequently, these pipes are often referred to as Mechanically Lined Pipe.
Typically, the casing, with an inner diameter smaller than carbon steel pipe, is inelastically expanded, resulting in residual contact stress. While the carbon steel pipe withstands most internal and external pressure loads, as well as tension and bending, the thin coating (2–4 mm) protects the line from corrosive effects.
However, in scenarios involving significant bending, such as during the spool installation method, the coating may detach from the outer tube, in extreme cases lead to wrinkling in the compression region and cause hindrances in the crude oil prospecting process.
This study aims to develop a numerical simulation in finite elements to evaluate the impact of internal pressure on wall separation during the installation process in a spool of coated pipes. This internal pressure can be caused by the bending stress, due to the forces applied, from the spool to the pipe. Stress at which it will be addressed in this simulation, it will have boundary and model conditions that allow the lowest possible computational cost.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper