This paper was published through Galoá and has a deposited DOI. To cite this paper, use one of the standards below:
In case you are one of the co-authors and want to register this paper in your Lattes, use the following code: doi > 10.17648/sobena-2024-195518
If you've NEVER registered a DOI in your Lattes, check our tutorial!Steel pipelines, used for oil and gas transmission, are exposed to various corrosive pollutants. To guarantee structural integrity against corrosion, double-walled ducts are produced, called “coated duct” or “bimetallic duct”. The manufacturing processes for coated ducts are done mechanically and metallurgically.
The metallurgical coating process, although it generates a stronger bond, is also very, very expensive, making the mechanical coating process a more economical option.
The mechanical coating process consists of inserting a thin layer of CRA (coating) inside an external duct in a concentric manner, maintaining an initial gap between the internal surface of the external duct and the external surface of the coating (GAP_0). The ends of the ducts are hermetically sealed, and then hydraulic pressure is applied to the inner surface of the lining and a compressive force proportional to the pressure, which induces both elastic and plastic expansion as the internal pressure increases. Throughout the manufacturing process, both external and internal ducts are plasticized. After the internal pressure is removed, a durable clamping force arises between the casing and the external duct due to property incompatibility and other factors. This interference contact force is a crucial indicator of the MLP that ensures structural soundness during installation and operation.
Significant challenges arise during installation to avoid problems arising from wrinkling and relative detachment of layers.
Given the limited literature available on the manufacture of bimetallic ducts with plasticization of the external duct, this study proposes to investigate the effect of partial plasticization. Using the J2 incremental flow theory and the J2 deformation theory, the model with hydraulic loading and compressive loading is analyzed. The results were validated using an axisymmetric FEM model. The findings showed that the introduction of partial plasticization in the external duct is advantageous for increasing the residual contact pressure.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper