Este trabalho foi publicado pelo Galoá e tem um DOI depositado. Para citar este trabalho, use um dos padrões abaixo:
Caso você seja um dos co-autores e queira cadastrar esse trabalho no seu Currículo Lattes, use o seguinte código: doi > 10.17648/sobena-2020-122855
Se você NUNCA registrou um DOI no seu Lattes, veja nosso tutorial!Numerical Study of the Hydrodynamic Coefficients of Simple Geometries under Forced Oscillations
Gustavo de Goes Gomes
FIPT (Fundação de Apoio ao Instituto de Pesquisas Tecnológicas)
Agora você poderia compartilhar comigo suas dúvidas, observações e parabenizações
Crie um tópicoAn important question regarding the installation or decommission of subsea equipment is the operational window needed for its deployment. This window is determined by factors such as the dynamics of the crane ship, the wind and sea conditions, and the hydrodynamics of the loaded equipment. This paper explores the latter factor, presenting a continuation of a previous work, concerned on the calculation of the hydrodynamic coefficients of submerged bodies under forced oscillation. These coefficients are obtained numerically using a commercial computational fluid dynamics software. In comparison with the previous work, unstructured three-dimensional meshes are employed, instead of structured two-dimensional meshes, to represent two types of simple geometries: discs and rectangular flat plates. Initially a study of the computational domain size is carried out to reduce the computational cost of the three-dimensional simulations. Furthermore, sinusoidal forced oscillations are used, in this case, to obtain the coefficients of additional mass and drag from a range of Keulegan-Carpenter numbers (KC). The KC values studied are between 0.25 and 1.5 for the discs and 0.09 to 1.88 for the plates. With these numerical studies conducted, the coefficient results were compared with data in the literature. In addition to the availability of experimental data, these geometries promote a gradual increase in complexity, since the first models created started with a two-dimensional simulation using axisymmetry, presented in the previous work, then the same geometry is simulated in a three dimensional mesh and finally, the same method is applied to a flat plate, which is still a simple geometry, but has a different type of symmetry. With the validation of both method and model, it is intended, in future work, to increase the complexity of the simulated geometries.
Com ~200 mil publicações revisadas por pesquisadores do mundo todo, o Galoá impulsiona cientistas na descoberta de pesquisas de ponta por meio de nossa plataforma indexada.
Confira nossos produtos e como podemos ajudá-lo a dar mais alcance para sua pesquisa:
Esse proceedings é identificado por um DOI , para usar em citações ou referências bibliográficas. Atenção: este não é um DOI para o jornal e, como tal, não pode ser usado em Lattes para identificar um trabalho específico.
Verifique o link "Como citar" na página do trabalho, para ver como citar corretamente o artigo