Comparison between the effects of high isostatic pressure and high pressure homogenization on the muramidase activity of the lysozyme
High isostatic pressure (HIP) and high pressure homogenization (HPH) are emerging technologies recently highlighted as able to improves enzymes activities. Lysozyme is an enzyme with antibacterial activity that is susceptible to changes by both the processes. This study evaluated the impact of HIP (pressures ranging from 100 to 600 MPa at 20 and 50ºC for 10 min) and HPH (pressures ranging from 40 to 190 MPa at inlet temperatures of 20 and 50ºC) on the muramidase activity of the lysozyme measured at optimum (50ºC, pH 5.5) and non-optimum conditions (pH 4.5 and 6.5, at 20 and 50 ºC). Results showed that HIP and HPH were able to change the enzyme activity of lysozyme, depending on the kind of process, process parameters (pressure, time, temperature) and on the conditions of activity measurement (pH and temperature). In general, low pressures (<120 MPa for HPH and <400 MPa for HIP) induced lysozyme activation, reaching maximum activation of 25 and 17% for samples processed by HPH and HIP, respectively. On the other hand, processes that used higher pressures or associated pressures and temperatures induced muramidase activity loss, especially those carried out using HIP at 600 MPa and 50ºC (inactivation up to 80%). The comparison between the results obtained for activity measured at optimum and non-optimum conditions showed that activity increase was higher for non-optimum conditions (<25% for HPH and < 17% for HIP ) when compared to optimum one (<20% for HPH and <10% for HIP). Therefore, the results obtained highlighted that HIP and HPH are able to improves muramidase activity of lysozyme, that pressures required for homogenization process (40-120 MPa) is lower than the required for isostatic one (300-400 MPa), that inactivation of enzyme is particularly higher for HIP associated with 50ºC and that better results of activation is obtained for non-optimum conditions.