To cite this paper use one of the standards below:
In the context of two-dimensional rectangular cutting of metal sheets, the objective of this research was to verify the behavior of the dynamics of direct operating costs associated with plasma arc cutting, from combinations of variations in sheet width and cutting speed. After verifying in the scientific literature the main direct operating costs associated with plasma arc metal sheet cutting, three categories of indicators were identified, the basic operating cost (IBOC), the direct labor cost (ICL) and the cost of non-value-generating activities (INV), which integrated originated the total direct operating cost (WAI) indicator. Next, in order to verify the plasma arc cutting process on sheet metal in an applied scenario, 12 simulations for each of the three generated instances (ODP71, ODP72 and ODP 74) were performed, based on the combination of the variations of sheet metal width (1050 mm, 1270 mm and 1500 mm) and cutting speed (1430 mm/min, 2110 mm/min, 2286 mm/min and 2800 mm/min). The arrangements of the rectangles on the sheet metal were obtained using the Best-Fit Decreasing Height (BFDH) heuristic. As a result, the simulated arrangements with the combination of variations with sheet metal width of 1270 mm and cutting speed of 2800 mm/min allowed an ICT of R$ 59.09 per cut sheet metal, considering the combination applicable to plasma cuts with acceptable quality of AISI/SAE 1020 steel sheets with a thickness equal to or less than 4 mm.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper