To cite this paper use one of the standards below:
Kaolinite is a primary material used in the production of ceramics, geopolymers, pharmacological products, cosmetics and fertilizers. The structural transformations in the clay mineral kaolinite (Si2Al2O5(OH)4) subjected to high-energy mechanical milling (HEMM) were studied using NMR techniques. HEMM is a well-established process to produce ultra-fine powders with specific granulometry and enhanced reactivity (1). Crystalline kaolinite has a pseudo-hexagonal structure, composed of three well-differentiated parallel layers, respectively formed by silicate tetrahedra of type Q3(1Al), octahedral Al, and hydroxyls bonded to Al (2). HEMM was performed in a planetary ball Mill. Sample extractions were done as a function of the grinding time up to 768 minutes. The entire process was carried out under argon atmosphere in a glove box (H2O < 1ppm) to avoid water absorption and contamination. In order to determine the nature of the structural changes induced in kaolinite during mechanical milling (degree of amorphization, identification of silicate species and Al coordination environments), solid-state high-resolution NMR techniques were applied to the 29Si, 1H and 27Al nuclei, at a magnetic field of 9.4 T. The 29Si-NMR spectra show the loss of intensity and broadening of the resonance lines of crystalline kaolinite with increasing milling time. Simultaneously, the emergence of new broad resonances associated with a distribution of silicate Qn groups with n = 1, 2, 3, 4 is observed, revealing the presence of an increasing fraction of amorphous material as a function of milling time. The {1H}-29Si cross-polarization experiments show that the Qn groups are coupled with 1H, indicating that this new material has OH groups relatively close to the silicate network. As a function of milling time, the 27Al-NMR spectra show the emergence of new Al sites in IV and V coordination and changes in the Al(VI) line shape associated with the increase in structural disorder. The {1H}-27Al-NMR spectra in cross polarization show that there is coupling between 1H and 27Al in these three coordinations. The 1H-NMR spectra indicate the emergence of new lines, which continue to be compatible with OH groups and also with H2O molecules. The increase in spectral broadening also indicates less mobility for these proton species within the new material. The analysis of the 1H-27Al cross-polarization experiments with variable contact time shows a substantial and systematic decrease in the TcH-Al contact time and spin-lattice relaxation time T1ρH with increasing milling time, revealing a higher effective dipolar coupling between 27Al-1H and a decrease in the H dynamics. The 27Al-{1H}-REDOR experiments show that practically all Al(V) and (VI) have dipolar coupling with 1H, with REDOR signal evolution curves having asymptotic values close to 0.9. In contrast, the REDOR evolution for Al(IV) shows that only 66% of these species are coupled with 1H. This last result indicates the insertion of Al(IV) within the silicate network in the amorphous material, making bonds with Q4 silicates, in positions far from OH groups. The 29Si-{1H} REDOR experiments reveal, on average, a weaker 29Si-1H dipolar coupling in the amorphous material than in the crystalline kaolinite. This decrease can be attributed to longer distances between 29Si and OH groups and/or to a greater presence of Si-O-Al(IV) bridges. The 29Si-NMR and X-ray diffraction results indicate the complete amorphization of kaolinite in the sample milled for 768 minutes, with the total loss of the Bragg diffraction planes characteristic of the crystal phase. The diffraction also points to a rapid amorphization of the material. It can be concluded that the mechanical milling of kaolinite produces a structurally disordered material where the lamellar structure is not preserved. The new material can be described as a complex amorphous network composed of connected alumino-silicates tetrahedra and distorted aluminate octahedra, and containing hydroxyls groups. The mechanical process can be an alternative route for the production of metakaolinite, the non-crystalline state of kaolinite produced by thermal treatments, avoiding the need of high-temperature processing.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper