To cite this paper use one of the standards below:
The Santos Basin Pre-salt interval contains important hydrocarbon reservoirs in lacustrine carbonate rocks. The porosity and permeability morphology and distribution in these reservoirs are complex, due to high-frequency intercalations of different facies and to intricate minerals relationships and diagenetic processes. The study facies are composed mostly of calcite spherulites and shrubs, formed soon after the deposition of a magnesian clay mineral matrix, such as kerolite or Mg-rich smectites. The formation of different clay mineral species was controlled by salinity, pH, Mg/Si ratio, temperature, detrital minerals input and biological substrate presence. An isotopic integrated investigation is essential to understand the singenetic and diagenetic processes that impact the reservoirs quality. To achieve this goal, samples for δD e δ18O isotopic data were selected from one well based on previous detailed petrographic analysis, major elemental (XRF) and mineralogical data (XRD). The δD e δ18O isotopic data were analyzed for cherts (n=5) and clay rich samples in which kerolite (n=2), Mg-smectites (n=3) and kerolite-smectite mixed layer (n=1) predominate, as well as δ18O isotopic data obtained from carbonates (n=4). The different clay mineral species show close δDV-SMOW and δ18OV-SMOW values, where δD=-25.5‰ and -36.7‰ (δDAv=-31.1‰) and δ18O=18.6‰ and 22.7‰ (δ18OAv=20.65‰) for kerolite samples; δD=-19.2‰ and δ18O=21.5‰ for the mixed layer sample; and δD between -20.5‰ and -22.7‰ (δDAv=-21.76‰) and δ18O between 17.2‰ and 21.6‰ (δ18OAv=20.00‰) for samples with Mg-smectites. Comparatively, other analyzed minerals (calcite, dolomite and silica) display δ18OV-SMOW significantly higher, between 28.36‰ and 35.6‰ (δ18OAv=32.2‰), with a single sample displaying the same δ18O values for dolomite and chert. Chert δDV-SMOW values show a wide dispersion, with values ranging from -79‰ and 13.5‰ (δDAv=38.58‰). The interpretation of stable isotopes composition in clay minerals comes with several technical challenges, such as the presence of different clay minerals and non-clay minerals in the separate fraction, the presence of structural, adsorbed and interlayer water, and the mixing of different isotopic compositions, as is the case with clay mixed layers. Therefore, mineral separation was done through cryogenic disaggregation, and the clay fraction was analyzed by XRD and FTIR, in order to confirm the analyzed phases. δ18O results for different clay minerals are similar to magnesian clay mineral values found in the Madrid Basin, however δD are significantly higher, and are compatible to smectites precipitated in saline environments such as salars (Li et al., 2019). The lower δD values found in kerolites are related to lower salinity and pH than those required for Mg-smectites. Considering the geochemical data, the lower Na2O values occur in clay mineral samples with lower δ18O, while a negative correlation between δD and Al+Fe+Ti+K/Mg (r²=0,98) occurs when kerolite samples are removed. This result agrees with clay minerals neoformation in lacustrine environments, given the direct relation between salinity and evaporation rate (Gebrehiorgis et al., 2020), as well as Al-Fe-Ti-K association to detrital minerals, which indicate a greater meteoric influx and salinity decrease. On the other hand, considering mineralogical data there is a strong negative correlation between δD and quartz content (r²=0.89), suggesting that silicification processes exerted a direct influence on clay mineral δD values. Similar and higher values of δ18O of other minerals when compared to clay minerals indicates calcite recrystallization, and dolomite and silica precipitation are from diagenetic processes that occurred after clay mineral formation, as evidenced by petrographic relations.
Gebregiorgis et al., 2020. DOI: 10.1029/2019GL085576
Li et al., 2019. DOI: 10.5772/intechopen.88532
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper