DIRECT ANALYSIS OF AIR FILTERS FOR TOXIC ELEMENTS SCREENING BY MIX-GAS PLASMA AND ETV-ICP OES
A fast analytical method to screening toxic elements in air filters was developed by using electrothermal vapourization coupled to inductively coupled plasma optical emission spectrometry (ETV-ICP OES) and direct insertion of small air filter pieces inside the boats. A careful optimization of the freon CHF3 flow (R-23, 0-10 ml min-1), pyrolysis (200-900ºC) and vaporization (1200-2400ºC) temperatures were carried out first in an univariate way to ensure proper ashing of the filter matrix and quantitative release of the analytes. To maximize sensitivity, a mix-gas ICP atmosphere was run by adding 0.45 L min-1 of N2 on the outer plasma Ar flow solely. Then, owing the shift of normal analytical zone in mix-gas plasma, another optimization in a multivariate way of the main parameters influencing sensitivity was carried out using a factorial design matrix with 10 experiments. The freon flow (two levels, 3.0 and 7.0 mL min-1), carrier Ar gas flow (three levels, 0.10; 0.30 and 0.5 L min-1) and by-pass Ar flow (three levels, 0.20; 0.45 and 0.70 L min-1) were used for this end. Quantification in ETV-ICP OES was performed by external calibration using increasing amounts of solid standard (NIST1648a, urban particle matter). To determinate the accuracy of the procedure all data was cross validated by ICP-MS, filters squares of 10 cm2 (~ 0.30 g) were digested using 2 mL of concentrated nitric acid over 48 h, completing the volume to 20 mL with high-purity water and the resulting solution was analysed by liquid nebulization ICP OES or alternatively liquid nebulization ICP-MS (with and without H2 as reaction gas CRI, 60 mL min-1 via the skimmer cone to search possible polyatomic interferences) for ultra-trace analysis. The analytes investigated were Al, Ti, V, Cr, Ni, Cu, As, Se, Sr, Mo, Cd, Sb and Pb and the average concentrations found were, in μg g-1, respectively, 38; 7; 1.50; 1.60; 14000; 3; <0.04; 6; <0.02; 0.50; 20 and 2. The results obtained using ETV-ICP OES (direct solid sampling), ICP OES or ICP-MS were in agreement in most cases. Further studies will include leaching studies to check the bioacessibility of such toxic elements using simulated saliva, gastric and lung fluids.