Para citar este trabalho use um dos padrões abaixo:
A huge number of semiconductor materials have been studied in photoelectrochemical (PEC) systems aimed to produce clean energy from water splitting under solar irradiation. Among them, Cu2O, a promising photocatalyst due to its optimum band gap (1.9 - 2.2 ev) with high coefficient of absorption in the visible region, good electrical conductivity, and simple preparation1-3. The nanostructured Cu2O can be prepared by different methods, such as electrodeposition, which additionally allows the control of the morphology and orientation, changing the deposition parameters, such as electrolyte pH, temperature, time of deposition, among others1-3. In the present work, nanostructured Cu2O thin films were electrodeposited on FTO glasses substrates according to the method reported by Qi et al (2016)1. The depositions were performed during 1500 seconds, with a constant current density of -1mA.cm-2, varying the temperature between 45 and 65 °C. The thin film crystallinity was evaluated on a Rigaku Ultima IV (type II) X-ray diffractometer with -2 geometry under the follow conditions: CuK, radiation =1.5418 Å); scan rate of 1º 2 min-1 with a width step of 0.05º 2. The Bragg reflections in the experimental PXRD patterns match those ones in the PDF (#65-3288) data-base. The experimental PXRD patterns of the Cu2O thin films obtained here exhibit typical Bragg peaks corresponding to the (100), (111), (200), (211), and (220) planes of the Cu2O phase (Figure 1). The morphological and microstructural characterization of the Cu2O thin films are underway.
Com ~200 mil publicações revisadas por pesquisadores do mundo todo, o Galoá impulsiona cientistas na descoberta de pesquisas de ponta por meio de nossa plataforma indexada.
Confira nossos produtos e como podemos ajudá-lo a dar mais alcance para sua pesquisa:
Esse proceedings é identificado por um DOI , para usar em citações ou referências bibliográficas. Atenção: este não é um DOI para o jornal e, como tal, não pode ser usado em Lattes para identificar um trabalho específico.
Verifique o link "Como citar" na página do trabalho, para ver como citar corretamente o artigo