77618

Extraction and Characterization of the Polysaccharide Obtained from the Aerial Yam (Dioscorea bulbifera)

Favorite this paper

Unconventional vegetables are so named because they are not consumed or very little consumed these days, but in former times they were used as a source of nutrients, besides being present in the folk medicine of specific regions. The aerial yam (Dioscorea bulbifera), for example, comes from the Asian and African continents, and was introduced into Brazil by the Portuguese settlers. It produces a reserve stem, which is rich in polysaccharides, can be used in cooking as a substitute for potatoes, but it is still not widely known and therefore has low commercial value [1]. The natural polysaccharides arouse interest due to its great biotechnological potential. In this sense, the objective of this work is the characterization of the polysaccharide extracted from the aerial yam, for possible application as a film in the production of apples and strawberries produced in our region, thus contributing in terms of food safety, besides adding value to the aerial yam. In this work, the extraction of the polysaccharide was done using the methodology suggested by Maity et al (2014) [2], with modifications, then dialyzed and oven dried at 40 °C. The characterization was performed using FTIR, SEM, NMR MAS13C, X-Ray Diffractometry and Thermal Analysis techniques. The FTIR presented an OH band in the region of 3500 cm-1. Through SEM it was possible to verify that the material is fibrous, in addition to having places where the structure presents faults; however, after drying, the polysaccharide forms a homogeneous film, indicating that it can be used in biofilms. Through X-Ray Diffractometry it was observed that the material is mostly amorphous, which is commonly seen in samples of this nature, and thus one of the possible uses of such material would be as a flocculant/coagulant. The thermal analysis indicates that the sample has three stages of mass loss, and it begins to degrade as soon as the temperature begins to rise, at approximately 24 °C, indicating that the material is not thermally stable, which is observed in materials of this nature in other works; the DTA shows a well-defined exothermic peak at 688.72 °C; through DTG it is possible to observe that there are three reactions that partially overlap in the region ranging from 150 to 300 °C, and at 677.9 °C a single stage decomposition reaction occurs. The 13C MAS NMR analysis showed that the sample is a polysaccharide as judged by a typical chemical shift at 103.5. 1H NMR as well as two-dimensional analyses are being done in order to confirm the structure of the polysaccharide obtained. From these results, microbiological analysis and antioxidant activity of this polysaccharide will be performed, in order to start the field application tests, since this work indicates that the sample analyzed has the capacity to form a biofilm.