The efficiency of homemade masks after successive washes

- 144022
Apresentação de Pôster
Favorite this paper
How to cite this paper?
Abstract

COVID-19 is an infectious disease caused by a newly discovered coronavirus. Is mainly transmitted through aerosols or droplets generated by an infected person. These droplets can remain in the air for a certain time, however, they quickly deposit on inert surfaces, causing cross infections. Therefore, the recommendation to prevent COVID-19 is to wash hands with soap and water, also using 70% alcohol hand for asepsis. Another recommendation is the use of protective masks, the most suitable being type N95. However, due to scarcity and high cost for the general population, the use of homemade masks became popular. Therefore, it is recommended the continuous use for 2 to 3 hours and its replacement, due to the humidity it presents, enough to facilitate the transmission of the virus, losing its efficiency as a mechanical barrier. The manufacture of these types of masks has been using different materials, from TNT, cotton fabric, to synthetic materials, with no restrictions on their reuse. Thus, the aim of this study was to evaluate the capacity of moisture retention masks made in different fabrics after several washings. The experiment was carried out at the Microbiology Laboratory of the State University of Northern Paraná - Campus Luiz Meneghel. The 6 homemade masks were obtained from the local market and were made with different fabrics: [1] TNT80; [2] Lightweight polyamide (89% polyamide and 11% elastane); [3] Tricholini blended (90% polyester and 10% cotton); [4] Tricolini Grafil (65% polyester and 35% cotton); [5] Testolen (50% cotton and 50% polyester); [6] TNT40. All masks were initially subjected to dry weighing at and 100% humidity (holding capacity). In addition, after each washing, the masks were placed in an autoclave with a steam flow for 1 minute to observe the retention of moisture absorbed by the tissues and after being weighed to check the retained moisture. The results demonstrate that the TNT40 mask in the first washes (4th) showed high moisture retention reaching 8% against 3.78% in the first wash. The same fabric, from day 6 onwards, has its fibers deteriorated. The same was verified in the TNT80, however, after the 8th. washing. Fabrics with synthetic composition showed lower initial moisture retention, but from day 9 onwards, retention was greater than 15%. Therefore, it is concluded that the reuse of homemade masks should be limited, that is, use a maximum of 5 washes.

Institutions
  • 1 Universidade Estadual do Norte do Paraná
Track
  • Clinical Microbiology
Keywords
COVID-19
physical barrier
Moisture
protection
dissemination