Oleogel-based emulsified systems can contribute to reducing the fat content in food products, showing good incorporation into food products. These structures contain an oleogel matrix in an emulsified system in which the aqueous phase is entrapped within the three-dimensional fat crystal network, obviating the requirement for an emulsifying agent. The present study aimed to develop a water-in-oleogel emulsion stabilized by rice white wax (RBW). To obtain the water-in-oleogel emulsions, firstly, the RBW (10% w/w) was homogenized in sunflower oil at 80 °C until completely dissolved. Then, water-in-oleogel emulsion was prepared by varying the water:oleogel mass ratio (20:80, 30:70, and 40:60) using a rotor-stator (Ultraturrax T-18) at 14,000 rpm for 3 min, slowly adding the water phase (80°C). Finally, the emulsion was cooled in an ice bath and stored at 5 °C for 24 hours before analysis. The emulsions were assessed in relation to physical stability for sedimentation index from centrifugation and rheological properties (frequency sweep at 5 and 25 °C). All emulsions showed G’ > G”, typical of gel-like behavior, regardless of the applied frequency (0.1 – 10 Hz). Interestingly, the increase in the aqueous fraction promotes an increase in the moduli, regardless the temperature (5 or 25 °C). In addition, G’’ of the emulsions at the lowest temperature was higher than that observed at 25 °C. This fact is correlated with the lower mobility of the structure at low temperatures as the crystalline network becomes compacted. All formulations kept stable for 7 days at both temperatures, with no phase separation. However, after centrifugation, emulsions with a higher oleogel content (70%) and temperature (25 °C) showed a slight reduction of emulsion stability, consistent with rheological findings. Thus, rice bran wax-stabilized water-in-oleogel emulsions hold potential to reduce saturated fat content in fat-based food formulations.