To cite this paper use one of the standards below:
This work presents the development of a data acquisition system for monitoring 3D printing processes, focusing on the identification of the printer's operational states through the use of sensors. The proposed approach integrates vibration, temperature, and humidity sensors connected to a microcontroller, allowing the simultaneous collection of dynamic and thermal data throughout the additive manufacturing process. The literature review highlights the importance of sensor positioning and data analysis in fault detection and in improving process quality. Experimentally, the acquired signals were analyzed during different stages of the printing process, revealing vibration patterns associated with distinct operating conditions and changes in printer activity. The results show that the developed system is capable of capturing consistent variations in the measured signals and identifying changes in the printer's behavior over time. The collected data also indicate the possible influence of thermal conditions on printing performance. Therefore, the proposed system demonstrates potential for intelligent monitoring of additive manufacturing processes and for supporting real-time fault detection and process analysis.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper