Accurate Determination of Moisture Content of Soft Contact Lenses by Near-Infrared (NIR) Spectroscopy
Near infrared (NIR) spectroscopy is a rapid, non-destructive method for analysis of routinely measured products. NIR can eliminate lost time and lost product while improving real time quality control. The delicate properties of soft contact lenses require a minimal-contact method for analysis to avoid damage to the lens itself. NIR spectroscopy provides a quick and damage-free solution. Four sets of soft contact lenses with known moisture levels were analyzed by NIR spectroscopy. The spectra were analyzed for quantitative model development.
Successful NIR method development starts with the proper sample presentation. To measure good NIR spectra, the proper sample presentation is of utmost importance for the delicate soft contact lenses. In this work we studied the influence of three different sample presentations, Reflectance, Trans-reflectance and Transmission. Calibration was built using all the sampling methods and the results were compared for prediction accuracy, precision, ease of use and damage to the product.
Four sets of lenses with varying embedded water quantities were available for analysis. The known embedded water content for these four sets were 24%, 38%, 48%, and 58%. 20+ spectra were used to build a spectral library for method development – using five to six samples from each of the four lots. Each spectrum consisted of 32 co-added scans of sample and reference in the scan range of 400-2500 nm. Consistent timing was required in order to reduce the effect from air drying. Each sample spectrum was collected in 16 seconds.
A quantitative model was developed in the Vision® chemometric software using spectra within the region above. A partial least squares regression model was developed from 1272-1648 nm to correlate the spectra profile with embedded moisture percentage. The trends for the various concentrations are clearly distinguishable. There was another water absorption band near 1900 nm, however this was not included in the model since it appeared to overlap with absorption features specific to the lens material. Note that absorption features in other regions of the spectrum could easily distinguish the differences in the lens material itself – with far better accuracy than the embedded water content.
The results indicate that NIR can be successfully used to monitor the percentage of embedded water in soft contact lenses. NIR measurements take approximately 15 seconds and offer a number of unique advantages over traditional methods of analysis including; no sample preparation, rapid analysis times, and recovery of the intact sample. The reference values submitted were rounded numbers. More accurate and precise lab values will result in more accurate NIR predictions. The submitted values were assumed to be label claim or estimates used for feasibility. The trans-reflectance offered easy sample presentation with good prediction, accuracy and intact sample recovery.