Use of cationic cellulose nanofibrils combined with exfoliated nanoclays for paper coating

Vol 1, 2025 - 323672
Poster presentation
Favorite this paper
How to cite this paper?
Abstract

Paper packaging has gained significant attention as a sustainable alternative to fossil-based plastic materials. However, due to its high porosity and hydrophilic nature, paper has poor barrier properties against water, oil, and gas permeation. Thus, paper packagings are often coated with waxes or synthetic polymers to improve their performance, but these coatings can compromise the substrates‘ biodegradability, repulpability, and recyclability. In this context, this work investigates the use of cationic cellulose nanofibrils (cCNF) and anionic exfoliated nanoclays, montmorillonite (MMT) and laponite (LAP), to enhance the barrier properties of paper as a greener alternative to conventional coatings. MMT and LAP are lamellar minerals with good exfoliation capacity in water, generating particles with high aspect ratio and surface area, characteristics that enhance composites‘ mechanical and barrier properties. cCNF was obtained by cationization reaction of cellulose pulp, with the introduction of –N(CH3)3+ groups on its surface, and subsequently subjected to mechanical fibrillation. The amount of cationic groups in cCNF was found to be 0.44 mmol g−1.  The exfoliation degree of the anionic minerals‘ suspensions was evaluated by UV-Vis spectroscopy after treatments by magnetic agitation, ultra-turrax homogenization, probe sonication, and microfluidization. Transmittance increases as more energetic methods are used, with microfluidization being the most effective method. The number of microfluidization cycles also significantly impacts the transmittance of the suspensions. An increase in the samples‘ transmittance suggests that smaller particles are present in suspension, indicating that mineral exfoliation may occur. cCNF and MMT or LAP suspensions were applied as multilayer coatings on paper board substrates. Permeability tests showed that the cCNF/MMT/cCNF three-layer coating reduced the water vapor transmission rate by up to 6.4% compared to the control group. Additionally, the cCNF/LAP/cCNF formulation showed a reduction of until 3,7% compared with mixture formulations (cCNF+LAP, in a 1:10 ratio), this demonstrates that layering oppositely charged components is beneficial for enhancing water barrier properties. With regard to the oil barrier, the cCNF/LAP/cCNF coating proved efficient, withstanding up to kit #12. Aiming at the application of coated papers in food packaging, future tests will evaluate the oxygen resistance, as well as the oil and grease barrier of MMT formulations. In addition, the study of the electrostatic interaction between cCNF and nanoclays will be deepened to understand its impact on the coating structure and improve substrates‘ barrier properties.

Share your ideas or questions with the authors!

Did you know that the greatest stimulus in scientific and cultural development is curiosity? Leave your questions or suggestions to the author!

Sign in to interact

Have a question or suggestion? Share your feedback with the authors!

Institutions
  • 1 Brazilian Nanotechnology National Laboratory (CNPEM); State University of Campinas (UNICAMP)
  • 2 Brazilian Nanotechnology National Laboratory (LNNano/CNPEM); Federal University of ABC (UFABC)
  • 3 Brazilian Center for Research in Energy and Materials
Track
  • ISP 2025
Keywords
cationic nanocellulose
montmorillonite
laponite
exfoliation
coating