To cite this paper use one of the standards below:
Black mulberry (Morus nigra) leaves, known for their bioactive properties, were subjected to ultrasound-assisted extraction (UAE) to enhance the recovery of phenolic compounds. The leaves were dried in a forced-air oven and milled prior to extraction. UAE conditions varied based on the sample-to-solvent (F/S) ratio (1:50 and 1:25), solvent composition (ethanol and 50% ethanol-water mixture, w/w), extraction times (2.5, 5, 7.5, and 10 minutes), and a fixed ultrasound power of 220 W. Among the tested conditions, the highest extraction yield and total phenolic content (TPC) were obtained with the 50% ethanol at an F/S ratio of 1:50 and 7.5-minute extraction time. This optimal condition yielded an extraction yield of 21.7% ± 1.1, with a TPC of 45.55 ± 1.11 mg GAE/g sample. Regarding solvent composition, the 50% ethanol showed an extraction yield similar to that of pure ethanol under the same conditions but achieved nearly three times higher phenolic recovery (ranging from 15.95 to 45.55 mg GAE/g). For both solvents, the F/S ratio of 1:50 was most effective in extracting both yield and phenolic compounds, suggesting that the 1:25 ratio likely led to solvent saturation with the extract. In general, phenolic recovery increased with extraction time up to 7.5 minutes, after which a decline was observed in most evaluated conditions, likely due to the degradation of phenolic compounds with prolonged US exposure. These findings suggest that UAE, particularly using a 50% ethanol solvent at optimized conditions, is a promising method for recovering phenolic compounds from black mulberry leaves, offering potential applications in the food and nutraceutical industries.
With nearly 200,000 papers published, Galoá empowers scholars to share and discover cutting-edge research through our streamlined and accessible academic publishing platform.
Learn more about our products:
This proceedings is identified by a DOI , for use in citations or bibliographic references. Attention: this is not a DOI for the paper and as such cannot be used in Lattes to identify a particular work.
Check the link "How to cite" in the paper's page, to see how to properly cite the paper